Yantai Beihai Complete Equipment Co., Ltd.

Electric cold room doors

Electric cold room doors
Product Detailed

1 rack drive to run smoothly.
2.specific conversion device automatically after power-off separation, easy to open.

1. The doors of high quality materials produced by the special treatment framework, covered with stainless steel or color steel panel, the overall polyurethane foam. Thickness of 100mm and 150mm.

2. Doors and, the door of the junction using a special setting, and resistance to low temperature, strong elastic rubber material, the form of two flat seals improve sealing performance.

3. Surrounded by low-voltage, high efficiency electric heater, doors and door frames and the horizon to prevent freezing of the side doors with safety switch, the door is closed, such as people or vehicles in the event of danger, able to automatically open, to avoid accidents .

4. The cone-shaped door three-phase motor, driven by deceleration after the chain rotation, rotating components that has the bearing. Road, rail forms a curve close to the door in place, it will automatically drop, pressed floors and door frames, to ensure a good sealing performance. Doors will open frame synchronization and separation increase, less the seal and the door frame and floor friction, so that the open light, close tightly.

5. Door with air curtain, air curtain when door is opened automatically.

6. The door also has a power failure and manual lock out of danger and internal discharge device. Of high quality electrical products, the unique design of advanced control, so the product has advanced structure, attractive appearance, good sealing performance, flexible control, and long service life. For temperature not lower than -40 ° C cold storage assembly, construction and cold temperature storage, heated workshop, indoor and outdoor temperature is greater than 50 ° C, library and outdoor air temperature is greater than 80% when they can play good every heat insulation effect, incoming and outgoing goods is essential to modern mechanized equipment.

The door main technical parameters are as follows:

1. door hole size: maximum 4000mm x 4000mm,

2. Applicable Temperature: -45 ° C-+50 ° C, door thickness of 63mm-200mm library matching low temperature: anti-freeze heat;

3. door control: Optional buttons, rope, ground magnetic, optical, radar control;

4.safety devices: photoelectric sensors, door crash sensors;

5.door leaf material: stainless steel or color steel plate;

6.door page number: optional single page or double page;

7. window: fog glass (optional);

8.Power: 220V/50Hz or 24V/50Hz (heating wire used), 3x380V/50Hz (Motor).



Copyright Notice @ 2008-2022 B2BAGE Limited and/or its subsidiaries and licensors. All rights reserved.